NETGEAR GSM7228PS - Show Ipv6 Ospf Interface Stats

Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-63
v1.0, July 2010
show ipv6 ospf interface stats
This command displays the statistics for a specific interface. The command only displays
information if OSPF is enabled.
Format show ipv6 ospf interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Admin Mode States whether OSPF is enabled or disabled on a router interface.
Area ID The OSPF Area ID for the specified interface.
Router Priority The router priority. The router priority determines which router is the designated router.
Hello Interval The frequency, in seconds, at which the interface sends Hello packets.
Dead Interval The amount of time, in seconds, the interface waits before assuming a neighbor is down.
Retransmit
Interval
The frequency, in seconds, at which the interface sends LSA.
Retransmit
Delay Interval
The number of seconds the interface adds to the age of LSA packets before
transmission.
LSA Ack
Interval
The amount of time, in seconds, the interface waits before sending an LSA
acknowledgement after receiving an LSA.
Format show ipv6 ospf interface stats <unit/slot/port>
Modes • Privileged EXEC
• User EXEC
Term Definition
OSPFv3 Area ID The area id of this OSPF interface.
IPv6 Address The IP address associated with this OSPF interface.
OSPFv3
Interface Events
The number of times the specified OSPF interface has changed its state, or an error has
occurred.