Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-101
v1.0, July 2010
no lacp partner port id
Use this command to set the LACP partner port id to the default.
lacp partner port priority
Use this command to configure the LACP partner port priority. The valid range for <priority>
is 0 to 255.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Format no lacp partner portid
Mode Interface Config
Default 0x0
Format lacp partner port priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner port priority
Mode Interface Config
To Next Page
Loading...
