NETGEAR GSM7228PS - Show Logging Buffered; Show Logging Hosts

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-22
v1.0, July 2010
show logging buffered
This command displays buffered logging (system startup and system operation logs).
show logging hosts
This command displays all configured logging hosts. The <unit> is the switch identifier and has
a range of 1-8.
Console Logging
Severity Filter
The minimum severity to log to the console log. Messages with an equal or lower
numerical severity are logged.
Buffered
Logging
Shows whether buffered logging is enabled.
Syslog Logging Shows whether syslog logging is enabled.
Log Messages
Received
Number of messages received by the log process. This includes messages that are
dropped or ignored.
Log Messages
Dropped
Number of messages that could not be processed due to error or lack of resources.
Log Messages
Relayed
Number of messages sent to the collector/relay.
Format show logging buffered
Mode Privileged EXEC
Term Definition
Buffered (In-
Memory)
Logging
Shows whether the In-Memory log is enabled or disabled.
Buffered
Logging
Wrapping
Behavior
The behavior of the In Memory log when faced with a log full situation.
Buffered Log
Count
The count of valid entries in the buffered log.
Format show logging hosts <unit>
Mode Privileged EXEC
Term Definition