Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-98
v1.0, July 2010
no lacp actor system priority
Use this command to configure the priority value associated with the Actor’s SystemID.
lacp partner admin key
Use this command to configure the administrative value of the Key for the protocol partner. The
valid range for <key> is 0 to 65535.
no lacp partner admin key
Use this command to configure the administrative value of the Key for the protocol partner.
lacp partner admin state individual
Use this command to set LACP partner admin state to individual.
Format no lacp actor system priority
Mode Interface Config
Default 0x0
Format lacp partner admin key
Mode Interface Config
Note: This command is only applicable to physical interfaces.
Format no lacp partner admin key <key>
Mode Interface Config
Format lacp partner admin state individual
Mode Interface Config
To Next Page
Loading...
