NETGEAR GSM7228PS - Provisioning (IEEE 802.1 P) Commands; Vlan Port Priority All; Vlan Priority

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-51
v1.0, July 2010
.
Provisioning (IEEE 802.1p) Commands
This section describes the commands you use to configure provisioning, which allows you to
prioritize ports.
vlan port priority all
This command configures the port priority assigned for untagged packets for all ports presently
plugged into the device. The range for the priority is 0-7. Any subsequent per port configuration
will override this configuration setting.
vlan priority
This command configures the default 802.1p port priority assigned for untagged packets for a
specific interface. The range for the priority is 0–7.
Term Definition
Voice VLAN Interface Mode The admin mode of the Voice VLAN on the interface.
Voice VLAN ID The Voice VLAN ID
Voice VLAN Priority The do1p priority for the Voice VLAN on the port.
Voice VLAN Untagged The tagging option for the Voice VLAN traffic.
Voice VLAN CoS Override The Override option for the voice traffic arriving on the port.
Voice VLAN Status The operational status of Voice VLAN on the port.
Format vlan port priority all <priority>
Mode Global Config
Default 0
Format vlan priority <priority>
Mode Interface Config