NETGEAR GSM7228PS - Set Mld Interfacemode

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-154
v1.0, July 2010
no set mld
Use this command to disable MLD Snooping on the system.
set mld interfacemode
Use this command to enable MLD Snooping on all interfaces. If an interface has MLD Snooping
enabled and you enable this interface for routing or enlist it as a member of a port-channel (LAG),
MLD Snooping functionality is disabled on that interface. MLD Snooping functionality is re-
enabled if you disable routing or remove port-channel (LAG) membership from an interface that
has MLD Snooping enabled.
Default disabled
Format set mld
Mode Global Config
Interface Config
Default disabled
Format set mld <vlanid>
Mode VLAN Mode
Format no set mld
Mode Global Config
Interface Config
Format no set mld <vlanid>
Mode VLAN Mode
Default disabled
Format set mld interfacemode
Mode Global Config