Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-31
v1.0, July 2010
The following information is repeated for interface and direction (only those interfaces configured
with an attached policy are shown):
show policy-map interface
This command displays policy-oriented statistics information for the specified interface and
direction. The <unit/slot/port> parameter specifies a valid interface for the system.
The following information is repeated for each class instance within this policy:
Term Definition
DiffServ Admin
Mode
The current setting of the DiffServ administrative mode. An attached policy is only active
on an interface while DiffServ is in an enabled mode.
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Direction The traffic direction of this interface service.
OperStatus The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Note: This command is only allowed while the DiffServ administrative mode is enabled.
Format show policy-map interface <unit/slot/port> [in]
Mode Privileged EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Direction The traffic direction of this interface service.
Operational
Status
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Term Definition
Class Name The name of this class instance.
To Next Page
Loading...
Need help?
General
