Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-37
v1.0, July 2010
no vlan port pvid all
This command sets the VLAN ID for all interfaces to 1.
vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to enabled. If tagging
is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as
untagged frames. The ID is a valid VLAN identification number.
no vlan port tagging all
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging
is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
vlan protocol group
This command adds protocol-based VLAN groups to the system. The <groupName> is a
character string of 1 to 16 characters. When it is created, the protocol group will be assigned a
unique number that will be used to identify the group in subsequent commands.
Format no vlan port pvid all
Mode Global Config
Format vlan port tagging all <1-4093>
Mode Global Config
Format no vlan port tagging all
Mode Global Config
Format vlan protocol group <groupname>
Mode Global Config
To Next Page
Loading...
