Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-47
v1.0, July 2010
area virtual-link authentication
This command configures the authentication type and key for the OSPF virtual interface identified
by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the
neighbor. The value for <type> is either none, simple, or encrypt. The [key] is composed of
standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. The
authentication key must be 8 bytes or less if the authentication type is simple. If the type is
encrypt, the key may be up to 16 bytes. Unauthenticated interfaces do not need an authentication
key. If the type is encrypt, a key id in the range of 0 and 255 must be specified.The default value
for authentication type is none. Neither the default password key nor the default key id are
configured.
no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface identified
by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the
neighbor.
area virtual-link dead-interval (OSPF)
This command configures the dead interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The range for seconds is 1 to 65535.
Default none
Format area <areaid> virtual-link <neighbor> authentication {none | {simple
<key>} | {encrypt <key> <keyid>}}
Mode Router OSPF Config
Format no area <areaid> virtual-link <neighbor> authentication
Mode Router OSPF Config
Default 40
Format area <areaid> virtual-link <neighbor> dead-interval <seconds>
Mode Router OSPF Config
To Next Page
Loading...
Need help?
General
