NETGEAR GSM7228PS - Show Mac-Address-Table Static; Show Mac-Address-Table Staticfiltering

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-119
v1.0, July 2010
The <vlanid> parameter must identify a valid VLAN.
show mac-address-table static
This command displays the Static MAC Filtering information for all Static MAC Filters. If you
select <all>, all the Static MAC Filters in the system are displayed. If you supply a value for
<macaddr>, you must also enter a value for <vlanid>, and the system displays Static MAC
Filter information only for that MAC address and VLAN.
show mac-address-table staticfiltering
This command displays the Static Filtering entries in the Multicast Forwarding Database (MFDB)
table.
Format no macfilter addsrc all <macaddr> <vlanid>
Mode Global Config
Format show mac-address-table static {<macaddr> <vlanid> | all}
Mode Privileged EXEC
Term Definition
MAC Address The MAC Address of the static MAC filter entry.
VLAN ID The VLAN ID of the static MAC filter entry.
Source Port(s) The source port filter set's slot and port(s).
Note: Only multicast address filters will have destination port lists.
Format show mac-address-table staticfiltering
Mode Privileged EXEC