Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-118
v1.0, July 2010
macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must identify
a valid VLAN.
no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
macfilter addsrc all
This command adds all interfaces to the source filter set for the MAC filter with the MAC address
of <macaddr> and <vlanid>. You must specify the <macaddr> parameter as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must identify
a valid VLAN.
no macfilter addsrc all
This command removes all interfaces to the source filter set for the MAC filter with the MAC
address of <macaddr> and VLAN of <vlanid>. You must specify the <macaddr> parameter
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
Format macfilter addsrc <macaddr> <vlanid>
Mode Interface Config
Format no macfilter addsrc <macaddr> <vlanid>
Mode Interface Config
Format macfilter addsrc all <macaddr> <vlanid>
Mode Global Config
To Next Page
Loading...
