Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-134
v1.0, July 2010
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 second, respectively.
ip arp inspection filter
Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If the static keyword is given, packets that do not match a permit
statement are dropped without consulting the DHCP snooping bindings.
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
Default 15 pps for rate and 1 second for burst-interval
Format ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode Interface Config
Format no ip arp inspection limit
Mode Interface Config
Default No ARP ACL is configured on a VLAN
Format ip arp inspection filter acl-name vlan vlan-list [static]
Mode Global Config
Format no ip arp inspection filter acl-name vlan vlan-list [static]
Mode Global Config
To Next Page
Loading...
