Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-42
v1.0, July 2010
no ip access-group
This command removes a specified IP ACL from an interface.
acl-trapflags
This command enables the ACL trap mode.
no acl-trapflags
This command disables the ACL trap mode.
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify the
IP ACL.
Default none
Format no ip access-group <accesslistnumber> [vlan <vlan-id>] in
Mode • Interface Config
• Global Config
Default disabled
Format acl-trapflags
Mode Global Config
Format no acl-trapflags
Mode Global Config
Format show ip access-lists <accesslistnumber>
Mode Privileged EXEC
Note: Only the access list fields that you configure are displayed.
To Next Page
Loading...
