NETGEAR GSM7228PS - System Utility and Clear Commands

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-24
v1.0, July 2010
logging persistent
Use this command to configure the Persistent logging for the switch. The severity level of logging
messages is specified at severity level. Possible values for severity level are (emergency|0,
alert|1, critical|2, error|3, warning|4, notice|5, info|6,
debug|7).
no logging persistent
Use this command to disable the persistent logging in the switch.
System Utility and Clear Commands
This section describes the commands you use to help troubleshoot connectivity issues and to
restore various configurations to their factory defaults.
Default Disable
Format logging persistent <severity level>
Mode Global Config
Format no logging persistent
Mode Global Config