NETGEAR GSM7228PS - Spanning-Tree Max-Hops; Spanning-Tree Mst

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-17
v1.0, July 2010
no spanning-tree max-age
This command sets the Bridge Max Age parameter for the common and internal spanning tree to
the default value.
spanning-tree max-hops
This command sets the MSTP Max Hops parameter to a new value for the common and internal
spanning tree. The max-hops value is a range from 6 to 40.
no spanning-tree max-hops
This command sets the Bridge Max Hops parameter for the common and internal spanning tree to
the default value.
spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree. If you specify an <mstid> parameter that
corresponds to an existing multiple spanning tree instance, the configurations are done for that
multiple spanning tree instance. If you specify 0 (defined as the default CIST ID) as the
<mstid>, the configurations are done for the common and internal spanning tree instance.
Format no spanning-tree max-age
Mode Global Config
Default 20
Format spanning-tree max-hops <1-127>
Mode Global Config
Format no spanning-tree max-hops
Mode Global Config