NETGEAR GSM7228PS - Maximum-Paths (Ospf); Redistribute (Ospf)

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-61
v1.0, July 2010
redistribute (OSPF)
This command configures OSPF protocol to allow redistribution of routes from the specified
source protocol/routers.
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the specified
source protocol/routers.
maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform dependent.
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its
default value.
Default • metric—unspecified
• type—2
• tag—0
Format redistribute {rip | static | connected} [metric <0-16777214>] [metric-
type {1 | 2}] [tag <0-4294967295>] [subnets]
Mode Router OSPF Config
Format no redistribute {rip | static | connected} [metric] [metric-type]
[tag] [subnets]
Mode Router OSPF Config
Default 4
Format maximum-paths <maxpaths>
Mode Router OSPF Config
Format no maximum-paths
Mode Router OSPF Config