Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-133
v1.0, July 2010
no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated VLAN
ranges.
ip arp inspection trust
Use this command to configure an interface as trusted for Dynamic ARP Inspection.
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
ip arp inspection limit
Use this command to configure the rate limit and burst interval values for an interface.
Configuring none for the limit means the interface is not rate limited for Dynamic ARP
Inspections.
Format no ip arp inspection vlan vlan-list logging
Mode Global Config
Default enabled
Format ip arp inspection trust
Mode Interface Config
Format no ip arp inspection trust
Mode Interface Config
Note: The user interface will accept a rate limit for a trusted interface, but the limit will
not be enforced unless the interface is configured to be untrusted.
To Next Page
Loading...
Need help?
General
