NETGEAR GSM7228PS - Show Ip Rip; Show Ip Rip Interface Brief

Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-89
v1.0, July 2010
show ip rip
This command displays information relevant to the RIP router.
show ip rip interface brief
This command displays general information for each RIP interface. For this command to display
successful results routing must be enabled per interface (i.e., ip rip).
Format show ip rip
Modes • Privileged EXEC
• User EXEC
Term Definition
RIP Admin Mode Enable or disable.
Split Horizon
Mode
None, simple or poison reverse.
Auto Summary
Mode
Enable or disable. If enabled, groups of adjacent routes are summarized into single
entries, in order to reduce the total number of entries The default is enable.
Host Routes
Accept Mode
Enable or disable. If enabled the router accepts host routes. The default is enable.
Global Route
Changes
The number of route changes made to the IP Route Database by RIP. This does not
include the refresh of a route's age.
Global queries The number of responses sent to RIP queries from other systems.
Default Metric The default metric of redistributed routes if one has already been set, or blank if not
configured earlier. The valid values are 1 to 15.
Default Route
Advertise
The default route.
Format show ip rip interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
IP Address The IP source address used by the specified RIP interface.
Send Version The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, RIP-2