Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-91
v1.0, July 2010
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of various
types of ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages. By
default, the generation of ICMP Destination Unreachable messages is enabled.
no ip unreachables
Use this command to prevent the generation of ICMP Destination Unreachable messages.
ip redirects
Use this command to enable the generation of ICMP Redirect messages by the router. By default,
the generation of ICMP Redirect messages is enabled.
no ip redirects
Use this command to prevent the generation of ICMP Redirect messages by the router.
Default enable
Format ip unreachables
Mode Interface Config
Format no ip unreachables
Mode Interface Config
Default enable
Format ip redirects
Mode • Global Config
• Interface Config
To Next Page
Loading...
