Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-47
v1.0, July 2010
mode dvlan-tunnel
Use this command to enable Double VLAN Tunneling on the specified interface.
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
show dot1q-tunnel
Use this command without the optional parameters to display all interfaces enabled for Double
VLAN Tunneling. Use the optional parameters to display detailed information about Double
VLAN Tunneling for the specified interface or all interfaces.
Note: When you use the mode dvlan-tunnel command on an interface, it becomes
a service provider port. Ports that do not have double VLAN tunneling enabled are
customer ports.
Default disabled
Format mode dvlan-tunnel
Mode Interface Config
Format no mode dvlan-tunnel
Mode Interface Config
Format show dot1q-tunnel [interface {<unit/slot/port> | all}]
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
Mode The administrative mode through which Double VLAN Tunneling can be enabled or
disabled. The default value for this field is disabled.
To Next Page
Loading...
