Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-66
v1.0, July 2010
If you specify an IP address for the neighbor router, the following fields display:
show ipv6 ospf range
This command displays information about the area ranges for the specified <areaid>. The
<areaid> identifies the OSPF area whose ranges are being displayed.
Term Definition
Interface The interface of the local router in unit/slot/port format.
Area ID The area ID associated with the interface.
Options An integer value that indicates the optional OSPF capabilities supported by the neighbor.
These are listed in its Hello packets. This enables received Hello Packets to be rejected
(i.e., neighbor relationships will not even start to form) if there is a mismatch in certain
crucial OSPF capabilities.
Router Priority The router priority for the specified interface.
Dead Timer Due The amount of time, in seconds, to wait before the router assumes the neighbor is
unreachable.
State The state of the neighboring routers.
Events Number of times this neighbor relationship has changed state, or an error has occurred.
Retransmission
Queue Length
An integer representing the current length of the retransmission queue of the specified
neighbor router Id of the specified interface.
Format show ipv6 ospf range <areaid>
Modes • Privileged EXEC
• User EXEC
Term Definition
Area ID The area id of the requested OSPF area.
IP Address An IP address which represents this area range.
Lsdb Type The type of link advertisement associated with this area range.
Advertisement The status of the advertisement: enabled or disabled.
To Next Page
Loading...
