NETGEAR GSM7228PS - Captive Portal User Group Commands

Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-31
v1.0, July 2010
Session Idle
User ID User Name Timeout Timeout Group ID Group Name
------- -------------- -------- -------- -------- -----------
1 user123 10 13 1 Default
2 user234 0 0 1 Default
(switch)#show captive-portal user 1
User ID........................................ 1
User Name...................................... user123
Password Configured............................ Yes
Session Timeout................................ 0
Idle Timeout................................... 0
Max Bandwidth Up (bytes/sec)................... 0
Max Bandwidth Down (bytes/sec)................. 0
Max Input Octets (bytes)....................... 0
Max Output Octets (bytes)...................... 0
Max Total Octets (bytes)....................... 0
Group ID Group Name
-------- --------------------------------
1 Default
2 group2
clear captive-portal users
Use this command to delete all captive portal user entries.
Captive Portal User Group Commands
The following section describes captive portal user group commands.
user group (Create)
Use this command to create a user group. User group 1 is created by default and cannot be deleted.
Format clear captive-portal users
Mode Privileged EXEC mode