Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-16
v1.0, July 2010
show telnetcon
This command displays the current inbound Telnet settings. In other words, these settings apply to
Telnet connections initiated from a remote system to the switch.
Secure Shell (SSH) Commands
This section describes the commands you use to configure SSH access to the switch. Use SSH to
access the switch from a remote management host.
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of the ip
ssh server enable command.)
Format show telnetcon
Modes • Privileged EXEC
• User EXEC
Term Definition
Remote
Connection
Login Timeout
(minutes)
This object indicates the number of minutes a remote connection session is allowed to
remain inactive before being logged off. May be specified as a number from 1 to 160. The
factory default is 5.
Maximum
Number of
Remote
Connection
Sessions
This object indicates the number of simultaneous remote connection sessions allowed.
The factory default is 5.
Allow New Telnet
Sessions
New Telnet sessions will not be allowed when this field is set to no. The factory default
value is yes.
Note: The system allows a maximum of 5 SSH sessions.
Default disabled
To Next Page
Loading...
