Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-52
v1.0, July 2010
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for authentication and
accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
DVMRP Traps Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP
traps are sent.
OSPFv2 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPF trap flags are not enabled, then the command displays
disabled. Otherwise, the command shows all the enabled OSPF traps’ information.
OSPFv3 Traps Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps are sent. If any of the OSPFv3 trap flags are not enabled, then the command
displays disabled. Otherwise, the command shows all the enabled OSPFv3 traps’
information.
PIM Traps Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
are sent.
Default disable
Format authorization network radius
Mode Global Config
Format no authorization network radius
Mode Global Config
Term Definition
To Next Page
Loading...
