NETGEAR GSM7228PS - Lldp Med Faststartrepeatcount; Lldp Med Transmit-Tlv All

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-184
v1.0, July 2010
lldp med faststartrepeatcount
Use this command to set the value of the fast start repeat count. [count] is the number of LLDP
PDUs that will be transmitted when the product is enabled. The range is 1 to 10.
no lldp med faststartrepeatcount
Use this command to return to the factory default value.
lldp med transmit-tlv all
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED set
will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default 3
Format lldp med faststartrepeatcount [count]
Mode Global Config
Format no lldp med faststartrepeatcount
Mode Global Config
Default By default, the capabilities and network policy TLVs are included.
Format lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode Global Config
Term Definition
capabilities Transmit the LLDP capabilities TLV.
ex-pd Transmit the LLDP extended PD TLV.
ex-pse Transmit the LLDP extended PSE TLV.
inventory Transmit the LLDP inventory TLV.
location Transmit the LLDP location TLV.
network-policy Transmit the LLDP network policy TLV.