Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-38
v1.0, July 2010
no ipv6 ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
ipv6 router ospf
Use this command to enter Router OSPFv3 Config mode.
area default-cost (OSPFv3)
This command configures the monetary default cost for the stub area. The operator must specify
the area id and an integer value between 1–16777215.
area nssa (OSPFv3)
This command configures the specified areaid to function as an NSSA.
no area nssa(OSPFv3)
This command disables nssa from the specified area id.
Format no ipv6 ospf transmit-delay
Mode Interface Config
Format ipv6 router ospf
Mode Global Config
Format area <areaid> default-cost <1-16777215>
Mode Router OSPFv3 Config
Format area <areaid> nssa
Mode Router OSPFv3 Config
Format no area <areaid> nssa
Mode Router OSPFv3 Config
To Next Page
Loading...
Need help?
General
