NETGEAR GSM7228PS - Set Igmp Querier Election Participate; Set Igmp Querier Version

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-151
v1.0, July 2010
set igmp querier version
Use this command to set the IGMP version of the query that the snooping switch is going to send
periodically.
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
set igmp querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process
when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the
Snooping Querier finds that the other Querier’s source address is better (less) than the Snooping
Querier’s address, it stops sending periodic queries. If the Snooping Querier wins the election,
then it will continue sending periodic queries.
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go into
non-querier mode as soon as it discovers the presence of another querier in the same VLAN.
Default 1
Format set igmp querier version <1-2>
Mode Global Config
Format no set igmp querier version
Mode Global Config
Default disabled
Format set igmp querier election participate
Mode VLAN Config
Format no set igmp querier election participate
Mode VLAN Config