Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-155
v1.0, July 2010
no set mld interfacemode
Use this command to disable MLD Snooping on all interfaces.
set mld fast-leave
Use this command to enable MLD Snooping fast-leave admin mode on a selected interface or
VLAN. Enabling fast-leave allows the switch to immediately remove the Layer 2 LAN interface
from its forwarding table entry upon receiving and MLD done message for that multicast group
without first sending out MAC-based general queries to the interface.
Format no set mld interfacemode
Mode Global Config
Note: You should enable fast-leave admin mode only on VLANs where only one host is
connected to each Layer 2 LAN port. This prevents the inadvertent dropping of the
other hosts that were connected to the same layer 2 LAN port but were still
interested in receiving multicast traffic directed to that group.
Note: Fast-leave processing is supported only with MLD version 1 hosts.
Default disabled
Format set mld fast-leave <vlanid>
Mode • VLAN Mode
Default disabled
Format set mld fast-leave
Mode • Interface Config
To Next Page
Loading...
