NETGEAR GSM7228PS - Ip Igmp Startup-Query-Count; Ip Igmp Startup-Query-Interval

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-30
v1.0, July 2010
ip igmp startup-query-count
This command sets the number of Queries sent out on startup, separated by the Startup Query
Interval on the interface. The range for <count> is 1 to 20.
no ip igmp startup-query-count
This command resets the number of Queries sent out on startup, separated by the Startup Query
Interval on the interface to the default value.
ip igmp startup-query-interval
This command sets the interval between General Queries sent on startup on the interface. The time
interval value is in seconds. The range for <interval> is 1 to 300 seconds.
no ip igmp startup-query-interval
This command resets the interval between General Queries sent on startup on the interface to the
default value.
Default 2
Format ip igmp startup-query-count <count>
Mode Interface Config
Format no ip igmp startup-query-count
Mode Interface Config
Default 31
Format ip igmp startup-query-interval <interval>
Mode Interface Config
Format no ip igmp startup-query-interval
Mode Interface Config