Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-25
v1.0, July 2010
policy-map rename
This command changes the name of a DiffServ policy. The <policyname> is the name of an
existing DiffServ class. The <newpolicyname> parameter is a case-sensitive alphanumeric
string from 1 to 31 characters uniquely identifying the policy.
DiffServ Service Commands
Use the DiffServ service commands to assign a DiffServ traffic conditioning policy, which you
specified by using the policy commands, to an interface in the incoming direction
The service commands attach a defined policy to a directional interface. You can assign only one
policy at any one time to an interface in the inbound direction. DiffServ is not used in the outbound
direction.
This set of commands consists of service addition/removal.
The CLI command root is service-policy.
service-policy
This command attaches a policy to an interface in the inbound direction. The <policyname>
parameter is the name of an existing DiffServ policy. This command causes a service to create a
reference to the policy.
Format policy-map rename <policyname> <newpolicyname>
Mode Global Config
Note: This command effectively enables DiffServ on an interface in the inbound
direction. There is no separate interface administrative 'mode' command for
DiffServ.
Note: This command fails if any attributes within the policy definition exceed the
capabilities of the interface. Once a policy is successfully attached to an interface,
any attempt to change the policy definition, that would result in a violation of the
interface capabilities, causes the policy change attempt to fail.
To Next Page
Loading...
Need help?
General
