Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-79
v1.0, July 2010
no storm-control broadcast
Use this command to disable broadcast storm recovery mode for a specific interface.
storm-control broadcast level
Use this command to configure the broadcast storm recovery threshold for an interface as a
percentage of link speed and enable broadcast storm recovery. If the mode is enabled, broadcast
storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is
limited to the configured threshold.
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an interface and
disables broadcast storm recovery.
Default enabled
Format storm-control broadcast
Mode Interface Config
Format no storm-control broadcast
Mode Interface Config
Default 5
Format storm-control broadcast level
<0-100>
Mode Interface Config
Format no storm-control broadcast level
Mode Interface Config
To Next Page
Loading...
