NETGEAR GSM7228PS - Ipv6 Pimsm Rp-Address

Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-11
v1.0, July 2010
no ipv6 pimsm register-threshold
This command resets the register threshold rate for the Rendezvous Pointer router to the default
value.
ipv6 pimsm rp-address
This command is used to statically configure the RP address for one or more multicast groups. The
parameter <rp-address> is the IP address of the RP. The parameter <groupaddress> is the
group address supported by the RP. The parameter <groupmask> is the group mask for the
group address. The optional keyword override indicates that if there is a conflict, the RP
configured with this command prevails over the RP learned by BSR.
no ipv6 pimsm rp-address
This command is used to statically remove the RP address for one or more multicast groups.
Default 0
Format ipv6 pimsm register-threshold <0-2000>
Mode Global Config
Format no ipv6 pimsm register-threshold
Mode Global Config
Default 0
Format ipv6 pimsm rp-address <rp-address> <group-address> <group-mask>
[override]
Mode Global Config
Format no ipv6 pimsm rp-address <rp-address> <group-address> <group-mask>
Mode Global Config