Managed Switch CLI Manual, Release 8.0.3
Management Commands 10-57
v1.0, July 2010
radius server msgauth
This command enables the message authenticator attribute to be used for the specified RADIUS
Authenticating server.
no radius server msgauth
The
no version of this command disables the message authenticator attribute to be used for the
specified RADIUS Authenticating server.
radius server primary
This command specifies a configured server that should be the primary server in the group of
servers which have the same server name. Multiple primary servers can be configured for each
number of servers that have the same name. When the RADIUS client has to perform transactions
with an authenticating RADIUS server of specified name, the client uses the primary server that
has the specified server name by default. If the RADIUS client fails to communicate with the
primary server for any reason, the client uses the backup servers configured with the same server
name. These backup servers are identified as the ‘Secondary’ type.
Format radius server msgauth <ipaddr|dnsname>
Mode Global Config
Field Description
ip addr The IP address of the server.
dnsname The DNS name of the server.
Format no radius server msgauth <ipaddr|dnsname>
Mode Global Config
Format radius server primary {<ipaddr|dnsname>}
Mode Global Config
To Next Page
Loading...
Need help?
General
