NETGEAR GSM7228PS - Ip Igmp Last-Member-Query-Interval; Ip Igmp Query-Interval

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-28
v1.0, July 2010
ip igmp last-member-query-interval
This command configures the Maximum Response Time inserted in Group-Specific Queries
which are sent in response to Leave Group messages. The range for <seconds> is 0 to 255
tenths of a second.
no ip igmp last-member-query-interval
This command resets the Maximum Response Time to the default value.
ip igmp query-interval
This command configures the query interval for the specified interface. The query interval
determines how fast IGMP Host-Query packets are transmitted on this interface. The range for
<queryinterval> is 1 to 3600 seconds.
no ip igmp query-interval
This command resets the query interval for the specified interface to the default value. This is the
frequency at which IGMP Host-Query packets are transmitted on this interface.
Default 10 tenths of a second (1 second)
Format ip igmp last-member-query-interval <seconds>
Modes Interface Config
Format no ip igmp last-member-query-interval
Modes Interface Config
Default 125 seconds
Format ip igmp query-interval <seconds>
Modes Interface Config
Format no ip igmp query-interval
Modes Interface Config