Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-11
v1.0, July 2010
no ipv6 hop-limit
This command returns the unicast hop count to the default.
ipv6 unicast-routing
Use this command to enable the forwarding of IPv6 unicast datagrams.
no ipv6 unicast-routing
Use this command to disable the forwarding of IPv6 unicast datagrams.
ipv6 enable
Use this command to enable IPv6 routing on an interface, including tunnel and loopback
interfaces, that has not been configured with an explicit IPv6 address. When you use this
command, the interface is automatically configured with a link-local address. You do not need to
use this command if you configured an IPv6 global address on the interface.
Format ipv6 hop-limit <hops>
Mode Global Config
Format no ipv6 hop-limit
Mode Global Config
Default disabled
Format ipv6 unicast-routing
Mode Global Config
Format no ipv6 unicast-routing
Mode Global Config
Default disabled
Format ipv6 enable
Mode Interface Config
To Next Page
Loading...
