NETGEAR GSM7228PS - Ip Dhcp Ping Packets; Service Dhcp

Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-49
v1.0, July 2010
no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and high-
address are valid IP addresses; each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid.
ip dhcp ping packets
Use this command to specify the number, in a range from 2-10, of packets a DHCP server sends to
a pool address as part of a ping operation. By default the number of packets sent to a pool address
is 2, which is the smallest allowed number when sending packets. Setting the number of packets to
0 disables this command.
no ip dhcp ping packets
This command prevents the server from pinging pool addresses and sets the number of packets to
0.
service dhcp
This command enables the DHCP server.
Format no ip dhcp excluded-address <lowaddress> [highaddress]
Mode Global Config
Default 2
Format ip dhcp ping packets <0,2-10>
Mode Global Config
Default 0
Format no ip dhcp ping packets
Mode Global Config
Default disabled
Format service dhcp
Mode Global Config