Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-74
v1.0, July 2010
debug lacp packet
This command enables tracing of LACP packets received and transmitted by the switch.
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD[183697744]: dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1, State: 0x47, Key:
0x36
no debug lacp packet
This command disables tracing of LACP packets.
debug mldsnooping packet
Use this command to trace MLD snooping packet reception and transmission. receive traces only
received MLD snooping packets and transmit traces only transmitted MLD snooping packets.
When neither keyword is used in the command, then all MLD snooping packet traces are dumped.
Vital information such as source address, destination address, control packet type, packet length,
and the interface on which the packet is received or transmitted is displayed on the console.
Format no debug ipv6 pimsm packet [receive|transmit]
Mode Privileged EXEC
Default disabled
Format debug lacp packet
Mode Privileged EXEC
Format no debug lacp packet
Mode Privileged EXEC
Default disabled
Format debug mldsnooping packet [receive|transmit]
Mode Privileged EXEC
To Next Page
Loading...
