Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-41
v1.0, July 2010
no area nssa translator-stab-intv (OSPFv3)
This command disables the nssa translator’s <stabilityinterval> from the specified area
id.
area range (OSPFv3)
This command creates a specified area range for a specified NSSA. The <ipaddr> is a valid IP
address. The <subnetmask> is a valid subnet mask. The LSDB type must be specified by either
summarylink or nssaexternallink, and the advertising of the area range can be allowed
or suppressed.
no area range(OSPFv3)
This command deletes a specified area range. The <ipaddr> is a valid IP address. The
<subnetmask> is a valid subnet mask.
area stub (OSPFv3)
This command creates a stub area for the specified area ID. A stub area is characterized by the fact
that AS External LSAs are not propagated into the area. Removing AS External LSAs and
Summary LSAs can significantly reduce the link state database of routers within the stub area.
Format area <areaid> nssa translator-stab-intv <stabilityinterval>
Mode Router OSPFv3 Config
Format no area <areaid> nssa translator-stab-intv <stabilityinterval>
Mode Router OSPF Config
Format area <areaid>
range <ipv6-prefix> <prefix-length> {summarylink |
nssaexternallink} [advertise | not-advertise]
Mode Router OSPFv3 Config
Format no area <areaid>
range <ipv6-prefix> <prefix-length>
Mode Router OSPFv3 Config
To Next Page
Loading...
Need help?
General
