Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-4
v1.0, July 2010
show network ndp
This command displays NDP cache information for the network port.
Example: The following shows example CLI display output for the command.
(Switch) #show network ndp
Neighbor Age
IPv6 Address MAC Address isRtr State Updated
-------------------------- ----------------- ----- -------- -------
3017::204:76FF:FE73:423A 00:04:76:73:42:3a Reachable 447535
FE80::204:76FF:FE73:423A 00:04:76:73:42:3a Delay 447540
ping ipv6
Use this command to determine whether another computer is on the network. Ping provides a
synchronous response when initiated from the CLI and Web interfaces. To use the command,
configure the switch for network (in-band) connection. The source and target devices must have
the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected through the default VLAN (VLAN 1), as long as
there is a physical path between the switch and the workstation. The terminal interface sends three
pings to the target station. Use the <ipv6-address|hostname> parameter to ping an
interface by using the global IPv6 address of the interface. Use the optional size keyword to
specify the size of the ping packet.
Default enabled
Format show network ndp
Mode • Privileged EXEC
• User EXEC
Field Description
IPv6 Address The IPv6 address of the interface.
MAC Address The MAC Address used.
isRtr Specifies the router flag.
Neighbor State The state of the neighbor cache entry. Possible values are: Reachable, Delay.
Age Updated The time in seconds that has elapsed since an entry was added to the cache.
To Next Page
Loading...
