NETGEAR GSM7228PS - Ip Pimsm Hello-Interval; Ip Pimsm Join-Prune-Interval

Managed Switch CLI Manual, Release 8.0.3
IP Multicast Commands 5-19
v1.0, July 2010
ip pimsm hello-interval
This command is used to configure the PIM-SM hello interval for the specified interface. The
hello interval is specified in seconds.
no ip pimsm hello-interval
This command is used to set the hello interval to the default value.
ip pimsm join-prune-interval
This command is used to configure the interface join/prune interval for the PIM-SM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value from 0 to
18000.
no ip pimsm join-prune-interval
Use this command to set the join/prune interval to the default value.
Default 30
Format ip pimsm hello-interval <0-18000>
Mode Interface Config
Format no ip pimsm hello-interval
Mode Interface Config
Default 60
Format ip pimsm join-prune-interval <0-18000>
Mode Interface Config
Format no ip pimsm join-prune-interval
Mode Interface Config