Managed Switch CLI Manual, Release 8.0.3
Captive Portal Commands 12-24
v1.0, July 2010
Example
(switch)#show captive-portal interface configuration status
CP ID CP Name Interface Interface Description Type
----- ------------ --------- ---------------------------- --------
1 Default 1/0/1 Unit: 1 Slot: 0 Port: 1 Gigabit Physical
(switch)#show captive-portal interface configuration 1 status
CP ID..................................... 1
CP Name................................... cp1
Interface Interface Description Type
--------- --------------------------------- --------
1/0/1 Unit: 1 Slot: 0 Port: 1 Gigabit Physical
Captive Portal Local User Commands
The following section describes captive portal local user commands.
user password
Use this command to create a local user or change the password for an existing user. The user-id is
user ID in the range of 1-128. The password is the user passord in the range of 8-64 characters.
You can also enter encrypted password using the parameter encrypted.
Format show captive-portal interface configuration [ <1-10>] status
Mode Privileged EXEC mode
Term Definition
CP ID The captive portal ID
CP Name The captive portal name
Interface The interface associated with the CP ID.
Interface
Description
The description of the interface
Type The type of the interface
To Next Page
Loading...
Need help?
General
