Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-19
v1.0, July 2010
no ipv6 nd suppress-ra
This command enables router transmission on an interface
.
ipv6 unreachables
Use this command to enable the generation of ICMPv6 Destination Unreachable messages. By
default, the generation of ICMPv6 Destination Unreachable messages is enabled.
no ipv6 unreachables
Use this command to prevent the generation of ICMPv6 Destination Unreachable messages.
ipv6 icmp error-interval
Use this command to limit the rate at which ICMPv6 error messages are sent. The rate limit is
configured as a token bucket, with two configurable parameters, burst-size and burst-interval.
The burst-interval specifies how often the token bucket is initialized with burst-size tokens. burst-
interval is from 0 to 2147483647 milliseconds (msec).
The burst-size is the number of ICMPv6 error messages that can be sent during one burst-interval.
The range is from 1 to 200 messages.
Format ipv6 nd suppress-ra
Mode Interface Config
Format no ipv6 nd suppress-ra
Mode Interface Config
Default enable
Format ipv6 unreachables
Mode Interface Config
Format no ipv6 unreachables
Mode Interface Config
To Next Page
Loading...
