Managed Switch CLI Manual, Release 8.0.3
Quality of Service (QoS) Commands 8-7
v1.0, July 2010
show classofservice trust
This command displays the current trust mode setting for a specific interface. The <unit/slot/
port> parameter is optional and is only valid on platforms that support independent per-port
class of service mappings. If you specify an interface, the command displays the port trust mode of
the interface. If you do not specify an interface, the command displays the most recent global
configuration settings.
show interfaces cos-queue
This command displays the class-of-service queue configuration for the specified interface. The
unit/slot/port parameter is optional and is only valid on platforms that support independent per-
port class of service mappings. If specified, the class-of-service queue configuration of the
interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format show classofservice trust [<unit/slot/port>]
Mode Privileged EXEC
Term Definition
Non-IP Traffic
Class
The traffic class used for non-IP traffic. This is only displayed when the COS trust mode is
set to trust IP Precedence or IP DSCP (on platforms that support IP DSCP).
Untrusted Traffic
Class
The traffic class used for all untrusted traffic. This is only displayed when the COS trust
mode is set to 'untrusted'.
Format show interfaces cos-queue [<unit/slot/port>]
Mode Privileged EXEC
Term Definition
Queue Id An interface supports n queues numbered 0 to (n-1). The specific n value is platform
dependent.
Minimum
Bandwidth
The minimum transmission bandwidth guarantee for the queue, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed and the queue operates
using best-effort. This is a configured value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict priority or a
weighted scheme. This is a configured value.
Queue
Management
Type
The queue depth management technique used for this queue (tail drop).
To Next Page
Loading...
