Managed Switch CLI Manual, Release 8.0.3
Routing Commands 4-34
v1.0, July 2010
<1/0/1> down 10
TrackRoute (pfx/len) State DecrementPriority
------------------------ ------ ------------------
10.10.10.1/255.255.255.0 down 10
show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the switch. A
DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies between clients
and servers when they are not on the same physical subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Format show ip vrrp interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid unit, slot, and port number separated by forward slashes.
VRID The router ID of the virtual router.
IP Address The virtual router IP address.
Mode Indicates whether the virtual router is enabled or disabled.
State The state (Master/backup) of the virtual router.
Default disabled
Format bootpdhcprelay cidoptmode
Mode Global Config
To Next Page
Loading...
