Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-36
v1.0, July 2010
ipv6 ospf network
This command changes the default OSPF network type for the interface. Normally, the network
type is determined from the physical IP network type. By default all Ethernet networks are OSPF
type broadcast. Similarly, tunnel interfaces default to point-to-point. When an Ethernet port is
used as a single large bandwidth IP network between two routers, the network type can be point-
to-point since there are only two routers. Using point-to-point as the network type eliminates the
overhead of the OSPF designated router election. It is normally not useful to set a tunnel to OSPF
network type broadcast.
no ipv6 ospf network
This command sets the interface type to the default value.
ipv6 ospf priority
This command sets the OSPF priority for the specified router interface. The priority of the
interface is a priority integer from 0 to 255. A value of 0 indicates that the router is not eligible to
become the designated router on this network.
no ipv6 ospf priority
This command sets the default OSPF priority for the specified router interface.
Default broadcast
Format ipv6 ospf network {broadcast | point-to-point}
Mode Interface Config
Format no ipv6 ospf network {broadcast | point-to-point}
Mode Interface Config
Default 1, which is the highest router priority
Format ipv6 ospf priority <0-255>
Mode Interface Config
To Next Page
Loading...
