Managed Switch CLI Manual, Release 8.0.3
IPv6 Multicast Commands 6-7
v1.0, July 2010
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pimdm neighbor 0/1
Interface Neighbor Up Time Expiry Time
Address (hh:mm:ss) (hh:mm:ss)
show ipv6 pimdm interface
Use this command to display PIM-DM configuration information for all interfaces or for the
specified interface. If no interface is specified, configuration of all interfaces is displayed.
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 pimdm interface 0/1
Slot/Port...................................... 0/1
IP Address..................................... 1.1.1.1
Subnet Mask.................................... 255.255.255.0
Hello Interval (secs).......................... 30 secs
Neighbor count................................. 3
Designated Router.............................. Not Supported
(Switch) #show ipv6 pimdm interface
Address Interface Neighbor Hello
Count Interval
--------- ------- -------- -------
192.168.37.6 0/1 2 30
192.168.36.129 0/2 2 30
Up Time The time since this neighbor has become active on this interface.
Expiry Time The expiry time of the neighbor on this interface.
Format show ipv6 pimdm interface [<unit/slot/port>|all]
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Mode Indicates whether PIM-DM is enabled or disabled on the specified interface.
PIM-DM Interface
Hello Interval
The frequency at which PIM hello messages are transmitted on this interface. By default,
the value is 30 seconds.
Term Definition
To Next Page
Loading...
