Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-112
v1.0, July 2010
show port-channel
This command displays an overview of all port-channels (LAGs) on the switch.
show port-channel system priority
Use this command to display the port-channel system priority.
Format show port-channel {<logical unit/slot/port> | all}
Mode • Privileged EXEC
• User EXEC
Term Definition
Logical
Interface
Valid unit, slot, and port number separated by forward slashes.
Port-Channel
Name
The name of this port-channel (LAG). You may enter any string of up to 15 alphanumeric
characters.
Link State Indicates whether the Link is up or down.
Admin Mode May be enabled or disabled. The factory default is enabled.
Type The status designating whether a particular port-channel (LAG) is statically or
dynamically maintained.
• Static - The port-channel is statically maintained.
• Dynamic - The port-channel is dynamically maintained.
Mbr Ports A listing of the ports that are members of this port-channel (LAG), in unit/slot/port
notation. There can be a maximum of eight ports assigned to a given port-channel
(LAG).
Device Timeout For each port, lists the timeout (long or short) for Device Type (actor or partner).
Port Speed Speed of the port-channel port.
Ports Active This field lists ports that are actively participating in the port-channel (LAG).
Load Balance
Option
The load balance option associated with this LAG. See “port-channel load-balance” on
page 3-107.
Format show port-channel system priority
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General
