NETGEAR GSM7228PS - Spanning-Tree Mst Instance; Spanning-Tree Mst Priority

Managed Switch CLI Manual, Release 8.0.3
Switching Commands 3-19
v1.0, July 2010
spanning-tree mst instance
This command adds a multiple spanning tree instance to the switch. The parameter <mstid> is a
number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The
maximum number of multiple instances supported by the switch is 4.
no spanning-tree mst instance
This command removes a multiple spanning tree instance from the switch and reallocates all
VLANs allocated to the deleted instance to the common and internal spanning tree. The parameter
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance to
be removed.
spanning-tree mst priority
This command sets the bridge priority for a specific multiple spanning tree instance. The
parameter <mstid> is a number that corresponds to the desired existing multiple spanning tree
instance. The priority value is a number within a range of 0 to 61440 in increments of 4096.
Format no spanning-tree mst <mstid> <cost | external-cost | port-priority>
Mode Interface Config
Default none
Format spanning-tree mst instance <mstid>
Mode Global Config
Format no spanning-tree mst instance <mstid>
Mode Global Config