Managed Switch CLI Manual, Release 8.0.3
Utility Commands 9-68
v1.0, July 2010
no debug igmpsnooping receive
This command disables tracing of received IGMP Snooping packets.
debug ip acl
Use this command to enable debug of IP Protocol packets matching the ACL criteria.
no debug ip acl
Use this command to disable debug of IP Protocol packets matching the ACL criteria.
debug ip dvmrp packet
Use this command to trace DVMRP packet reception and transmission. receive traces only
received DVMRP packets and transmit traces only transmitted DVMRP packets. When neither
keyword is used in the command, then all DVMRP packet traces are dumped. Vital information
such as source address, destination address, control packet type, packet length, and the interface on
which the packet is received or transmitted is displayed on the console
Group Multicast group address in the IGMP header.
Format no debug igmpsnooping receive
Mode Privileged EXEC
Default disabled
Format debug ip acl <acl Number>
Mode Privileged EXEC
Format no debug ip acl <acl Number>
Mode Privileged EXEC
Default disabled
Format debug ip dvmrp packet [receive|transmit]
Mode Privileged EXEC
Parameter Definition
To Next Page
Loading...
