Managed Switch CLI Manual, Release 8.0.3
IPv6 Commands 7-70
v1.0, July 2010
ipv6 dhcp relay-agent-info-opt
Use this command to configure a number to represent the DHCPv6 Relay Agent Information
Option. The DHCPv6 Relay Agent Information Option allows for various sub-options to be
attached to messages that are being relayed by the local router to a relay server. The relay server
may in turn use this information in determining an address to assign to a DHCPv6 client.
ipv6 dhcp relay-agent-info-remote-id-subopt
Use this command to configure a number to represent the DHCPv6 the “remote-id” sub-option.
Note: If <relay-address> is an IPv6 global address, then <relay-interface> is not
required. If <relay-address> is a link-local or multicast address, then <relay-
interface> is required. Finally, if you do not specify a value for <relay-address>,
then you must specify a value for <relay-interface> and the DHCPV6-ALL-
AGENTS multicast address (i.e.
FF02::1:2) is used to relay DHCPv6 messages
to the relay server.
Format ipv6 dhcp relay {destination [<relay-address>] interface [<relay-
interface>]| interface [<relay-interface>]} [remote-id (duid-ifid |
<user-defined-string>)]
Mode Interface Config
Default 32
Format ipv6 dhcp relay-agent-info-opt
<32-65535>
Mode Global Config
Default 1
Format ipv6 dhcp relay-agent-info-remote-id-subopt <1-65535>
Mode Global Config
To Next Page
Loading...
